First of all you will need the following two binaries: auth and iwcontrol. One possible source for them is official DLink sourcecode tarball for G700AP, for example found here, or search for them in INet or on forums listed at rtl8186.sourceforge.net. Also binaries from compatible firmwares (such as firmwares for some models of Edimax) are reported to work.
download firmware para rtl8186 18
Hi to all, today I successfully flash the firmware of G700ap access point to wive-ng firmware, before I already done it but with no success for bridge or client mode.. after failing to flash in aprouter firmware and c3 firmware, I flashed it back again to wive-ng 3.17, I remember that Ive download a latest version of wive-ng version 3.18 firmware last 2 weeks ago, I immediately flash my radio to 3.18 and configure using the menu command at shell prompt.. guest what??? I connected it to my neighbors AP using this router with a simple configuration and using the "wl scangraph" I see that I was connected, and after that I change my wired lan card to dhcp, successful the IP of the AP that ive connected became my gateway and dns server... email me at erwin_husana@yahoo.com if you wanna know how I do it.. gud luck for other brickers out there.. LOL 2ff7e9595c
Comments